How do i hook up two amps in my car - Video Dailymotion How do i hook up two amps in my car - Video Dailymotion

Can i hook up 2 amps in my car, add your answer

How Do I Hook Up My Amp In My Car. Shut Up And Take My Money - Cool Gadgets and Geeky Products

Annie October 3, at If you do two or more connectors on a particular bunch, your not gaining much because the charge will still have to go through the single wires that come out of the PSU, which is what you're trying to avoid in the first place. Dante June 26, at I was thinking the kicker cxa I saw the specs on the amp and saw that it pushed out more RMS to the subs under a 2 ohm load.

If your using an independent PSU, make sure it's plugged in. It already has 2 factory subs under the seats. Connect them to The Amp.

There is a method to the madness; if you unplug all your drives and your video card, you should be able trace all the wires back to 2 or 3 bunches unless you have a modular PSU, in which I'm not sure how this would workyou'll want to connect the amp to as many bunches as you can.

Danny June 29, at 9: Thanks Annie April 6, at 8: Make sure that there's just bare wire at the end of all of the wires coming from your amp. How would I be able to install the most optimal setup possible?

The place where i got the amp installed said that la roja chilena online dating oem unit cant be amped.

1 Suggested Answer

Tejas January 28, at 5: So in the future there may be some nice options. Rob G February 4, at 6: Ben March 23, at 1: Annie September 24, at 3: Everything Else - cyshi-beloyarsky. Fred hamdun February 16, at The car is canbus equipped. You would need to use the remote turn on lead from your aftermarket radio usually blue with a white stripe and wire that to the amp turn on lead in the car harness.

Previously had the same amp and sub with zero distortion. Can i hook up two subs to one amp - The phrase actually refers to wiring the sub-woofers up to a bridged amplifier to produce fuller, deeper bass. With this processor you also have the option of using a digital aux in so for a dedicated super high fidelity source, you can use an iPod running through a high quality digital to analog convertor straight into the processor.

Dies ist KEINE Dating-Site!

Additionally I would get a bass knob so you can have an independent sub level volume control as opposed to adjusting the bass on the head unit which will adjust bass levels to all speakers. Can i hook up two subs to one amp In other words, you can tell the bass is coming from a box in the trunk.

You could also hook up a car radio to your PC if you'd like, but I haven't done it yet so I don't have a guide.

gayle flirting interview

I think maybe you just mean running along side with rear speakers operating. Or do you prefer I try to purchase maybe a more up to date amp for my optimal set up.

How to hook up an amp and sub to a stock stereo.

Super Mario Coaster Set! The LOC is your input signal.

maria tochter ihres soehne online dating

The factory system is the beats audio. So linking strong to weak path perhaps create that sort of overly saturated situation, I think.

Erhalten Sie personalisierte Werbung von Partnern unseres Vertrauens

Be careful with the treble too. When the install is complete and I hook back up the battery neg terminal to the car, the system works and sounds good. If your amp uses more than around watts you'll want to use multiple molex connectors, because a single gauge wire might not be able to hold all the charge needed for the entire amp, causing it to heat up and possibly melt.

You may need to do an audio processor that sums the frequencies off the stock amp prior to your aftermarket amplifier so you can get a true full range signal.

ostentatious in a sentence yahoo dating

It'll probably be overwhelming. Annie April 6, at 8: And while feeding the amp output back to speakers n subs we connect speaker wires to each speaker leads, so whats the difference between amp input signal n amp output signal, its confusing me as for eg.